E1 to 10(100)Base-T Protocol Converter
E1 support Both 75ohm & 120ohm Impedance, unframed & framed mode
The device FHC-3100-A Network Bridge is a high performance, remote, self-learning Ethernet bridge. Its compact size and low cost make it ideal for cost-sensitive bridging applications, or as a LAN extender over bit stream type infrastructures. Its E1 data interface also provides an economical digital access solution for E1 and Fractional E1 network Services, which can work at data rates of 64Kbps to 2048Kbps. User’s data is placed into the E1 frame using only the required number of timeslots. Timeslot assignment is accomplished according to the Data Port speed and manual setting of DIP switches. The main E1 link may be clocked from the recovered receive clock or from an internal oscillator. For easy to check the fault of network line, the device provides loop selection, both local loop and remote loop.
Features
High performance bridge for 10(100)Base-T Ethernet extension
Fully compatible with IEEE 802.3 and Ethernet Standards
E1 channel: both framed & unframed are OK, both 75 & 120ohm are OK
Ethernet Port: 10Mbps, Full/Half Duplex Mode compatible
Ethernet ports support MDI/MDI-X selectionable
Allow transmitting and receiving VLAN data packet
15000 frames per second filtering and forwarding rate
1000 MAC address LAN table, and automatic LAN table learning and aging
Standalone and Module optional
Power of Chassis: 2 Slots for slide in power supplier module, AC or DC power supplier module, Redundant Power supported
AC220V±20% or DC-48V power input
Specifications
LAN port
Standard: Conforms to IEEE802.3 / 10(100)Base-T Ethernet
Data rate: 10Mbps(20Mbps/10Base-T in Full duplex topology)
Compatible on Full/Half duplex topology
Connectors: RJ-45 Connector
Transfer distance: <150m
E1 port
Standard: ITU G.703, G.704,
Jitter Performance: According to ITU G.823
Bit rate: N×64Kbps, N=1~31 (Fractional Mode) or 2.048Mbps(Full Mode)
Line Code: HDB3
Line Impedance: 75/120ohms optional
Pulse Amplitude: Nominal 2.37V±10%
General
Voltage: AC 220V±20% or DC -48V
Power Consumption: <3 Watts
Temperature: 0-50℃
Humidity: 0-90%(non-condensing)
Size: (Width: from left to right)
Standalone: 272mm(Width)× 139mm(Deep)× 41mm(High)
Chassis: 438mm(Width)× 252mm(Deep)× 178mm(High)